| HOW TO INSTALL THE OVERHEAD ASSIST BAR | ||
The AccuDock "overhead assist bar" has made its mark in Kayaking and Rowing worldwide. It has helped young and old, weak and strong, make the treacherous action of getting into and out of a Kayak more easy and safe.  See "Overhead Assist Bar" YouTube video of "So easy a two year old can do it". The overhead assist bar can be positioned anywhere along the frame of the "slip" except at the extreme end of the float. Once your kayak dock is totally installed. Put your kayak in the water and move into the slip. You may want to try going in forward and backwards - to find the best position and ensure that (in the case of long Kayaks) you have plenty of dock space to get off onto - when in the slip. Establish where you want the Overhead Assist Bar positioned. Put it into position - the aluminum connector slides between the lid "lip" of the float and the aluminum frame of the float. You will need to slide it in at an angle as shown below. Try it out (before you permanently affix it into place) - and slide it forward or back until you have it where you want it. (remember it is not permanently bolted in place yet, so don't put all your weight on it yet) Once you have established the correct spot - you can bolt it into position - keeping in mind that you can always change the position later if needed. Your "Overhead Assist Bar" is installed. If you have bump strip installed or are going to install bump strip - remove the bump strip portion from the slip area of the kayak dock, and install it back on after installation of the assist bar. (see HOW TO INSTALL BUMP STRIP) You will have to alter the bump strip by cutting a small area out of the top lip of the bump strip with a razor knife to make room for the assist bar.  | ||
|
|||
Copyright © AccuDock All rights reserved |
   |
||
{ Home | Res. Floating Dock Products | Com. Floating Dock Products | Support | News | Contact }
AccuDock
1336 SW 8th Street
Pompano Beach, Florida 33069
954-785-7557
Info@accudock.com